CabMasterPro User Guide
In This Topic
    Floors Tool Formula Reference
    In This Topic

    Any controls on this page which can be accessed with a formula are marked with a reference number.

    To view the formula name, hold your mouse over the control or click on  the control to look up the reference in the table below.

    For more information on other pages or categories, simply click on the area of interest.

    To find out what this property page is used for, see discussion on Floors Tool under Drawing Tools.


    Ref Variable Name
    1 IsTiled
    2 TopViz (see Note 2 below)
    3 TileWidth
    4 TileDepth
    5 IsReflect
    6 ReflectPer
    7 SlopeMode (see Note 1 below)
    8 CDepth (see Note 2 below)
    9 TBA

    Note 1

    SlopeMode

    The selection of the radio button sets the value of SlopeMode i.e.

    • Fixed = 1
    • Sloped = 2
    • Independent = 3

    Note 2

    Depth

       

     

    CDepth controls the value of the Surface Depth on the Standard > Heights page

     

     

    Will be invisible when viewing up from underneath the room if set to OneWay on the Standard > Heights page (Invisible from back). For example, from a viewpoint lower than floor level looking slightly upwards.

     

    Formula support was added for one way and depth of both floors and ceilings.

    Other variables available to middleware…

    NEW: Middleware variables for ceilings and floors, use arrays or single values which auto extend to all vertices

    NOTE1: height[1] etc does lookup or set for individual vertex heights    [CR there is a height[v] defined below?]

    NOTE2: allheights to set all vertices to same value or formula

    NOTE3: allheightssame checks whether all vertices have same height, value is yes or no