CabMasterPro User Guide
In This Topic
    Line
    In This Topic

    Purpose

    Create a straight line from the start to end point.

    Fields

    SecMin The X, Y, Z co-ordinates of the min corner of the section which this machining step is inside.
    SecMax The X, Y, Z co-ordinates of the max corner of the section which this machining step is inside.
    JoinMin The X, Y, Z co-ordinates of the min corner of the section which this machining step is joined to.
    JoinMax The X, Y, Z co-ordinates of the max corner of the section which this machining step is joined to.
    CutSize X, Y, Z contain the values from this component dimcut1, dimcut2, dimcut3 respectively.
    FinishedSize X, Y, Z contain the values from this component dim1, dim2, dim3 respectively.
    PartID A name for this step, init as component name, not sent to DXF usually.
    Layer The layer name written to the DXF, init as steptype but you should set this to something more meaningful e.g. in EzyNest. In addition, this layer value can be prefixed by + - or ~. The prefix is not sent to the DXF, but is used to indicate notches, where two steps are combined. A + is for combining two steps by adding the paths together. This can extend the outer shape. A - is used for subtracting or creating a notch. And a ~ is for flap donor steps. (See Flaps In Remote Components)
    Group The group name written to the DXF. Default value is ungrouped. Different groups will be nested separately, so for example a DXF with some ungrouped machine steps and some steps in group 10 and others in group 20 will nest as three separate parts.
    ColorIndex The color used in the DXF (usually unused by Machining but very helpful for viewing). Colors are defined by Voloview DXF viewer. (See also DXF Layer Colours):
    • 0 - Black
    • 1 - Red
    • 2 - Yellow
    • 3 - Green
    • 4 - Cyan
    • 5 - Blue
    • 6 - Magenta
    • 7 - Black(Again)
    • 8 - Grey
    • 9 - Brown
    • 10 - Khaki
    • 11 - Dark Green
    • 12 - Steel Blue
    • 13 - Dark Blue
    • 14 - Purple
    • 15 - Dark Grey
    Depth Depth of the of the cut/drill.
    Start XYZ: location of start of the machining step.
    End XYZ: location of end of the machining step.
    RepeatCount X: Whole machine step is repeated this many times. Y: If this is >1, then do a rectangular array of repeats.
    RepeatOffset

    XY: Offset vector between copies (for linear repeats). For arrays of repeats, X is the X offset and Y is the Y offset.

    Example

    Here is a little example of a BorderDeco step repeated in a 3x2 array:

    Repeat Example

    ProfileFolder Folder for QPFs, default BitmapFolder, can be relative.
    ProfileName Name of the profile. The default extension is ".qpf". An array of names is allowed, if defining multiple profile edging.
    ProfileEdging Array of edge treatments. See Edge and Pocket Profile Tutorial : Defining a Profile
    Pocket

    Entry is a yes/no determining whether the area inside the machinestep is to be removed. Applies to contours (closed polylines only).  

    See Edge and Pocket Profile Tutorial : Pocket